NOTE
The electrical service to the washer must conform with local
codes and ordinances and the latest edition of the National
Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian
Electrical Code C22.1 part 1.
WARNING
SUFFOCATION HAZARD
Destroy the carton and plastic bags after the washer is
unpacked. Children might use them for play. Cartons covered
with rugs, bedspreads, or plastic sheets can become airtight
chambers causing suffocation. Place all materials in a
garbage container or make materials inaccessible to children.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person
move or lift the washer.
WARNING
FIRE HAZARD
For your safety the information in this manual must be
followed to minimize the risk of fire or explosion or to prevent
property damage, personal injury or loss of life. Do not store
or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Tools and materials needed for installation:
OR
Adjustable
3/8" or
wrench
10 mm
box wrench
Important Safety Instructions
OR
AND
Ratchet and
socket set
NOTE
Hoses are not included with washer purchase.
See "Accessories" section for various inlet hose
kits to fit your specific installation.
Inlet hose (x2)
IMPORTANT
The instructions in this manual and all other literature included
with this washer are not meant to cover every possible
condition and situation that may occur. Good safe practice
and caution MUST be applied when installing, operating and
maintaining any appliance.
Maximum benefits and enjoyment are achieved when all
the Safety and Operating Instructions are understood and
practiced as a routine with your laundering tasks.
IMPORTANT
DO NOT INSTALL YOUR WASHER:
1 ... in an area exposed to dripping water or outside
weather conditions. The ambient temperature should
never be below 60° F (15.6° C) to maximize detergent
effectiveness.
2 ... in an area (garage or garage-type building) where
gasoline or other flammables (including automobiles) are
kept or stored.
3 ... on carpet. Floor MUST be solid with a maximum slope
of 1 inch (2.5 cm). To minimize vibration or movement,
reinforcement of the floor may be necessary.
OR
Optional uni-
Adjustable
versal wrench
pliers
available from
dealer
3
AND
Carpenter's level