Connections; Supply Battery Charging Process - Calira Sealine LG 660-DS/IU Mode D'emploi

(
high ambient temperature, the charging current is automatically reduced in
steps.

Connections

1 Female device plug connection
2 Generator inlet D+
3 Connection for temperature sensor 8 Output - charge cable for battery I
4 Connection for charge control
panel
5 Input B+ from battery II
Fig. 1: Connections
Supply battery charging process (battery II)
The charger has electronic protection against polarity inversion. The charging
current is only released once the battery is correctly connected and a minimum
voltage of 1.5 V is applied. During the charging process, the battery voltage is
constantly being monitored through the measuring cable B+. The charging
process follows the charging characteristic curve, with minimal energy loss
(for the charging characteristic curve, Fig. 2).
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806
""# $ %&'
6 Output + charge cable for battery
II
7 Output + charge cable for battery I
9 Output - charge cable for battery II
10 Changeover switch gel battery /
liquid electrolyte battery
21