Calira Sealine LG 660-DS/IU Mode D'emploi page 29

(
""# $ %&'
battery II. For cable lengths of over 1 m, this cable must be equipped with a 60
A fuse near the positive pole of the battery II!
Starter battery
Connect the charger to the starter battery (battery I) in accordance with the
connection diagram. Pay attention to the cable cross-sections and ensure
correct polarity.
Connect the negative charging cable battery I (blue 16 mm²) to negative output
of the device and the negative pole of the battery I.
Connect the positive charging cable of the battery I (red 16 mm²) to the
positive output for the battery of the device and the positive pole of the battery
I. It is essential to install a 60 A fuse near the positive pole of the battery I!
Use the provided Midi-fuse.
Measuring cable
Connect the measuring cable (red 0.75 mm²) to the B+ input of the device and
the positive pole of the battery. For cable lengths of over 1 m, this cable must
be equipped with a 2 A fuse near the positive pole of the battery II!
Generator
Connect the charger to the D+ contact of the generator in accordance with the
connection diagram.
Connect the cable (brown 0.75 mm²) to the D+ input of the device and to the
D+ contact of the generator. It is essential to install a 2 A fuse near the
generator! The fuse serves to protect the circuits
Charging control panel
If you are using a charge control panel, connect it to the 7-pole LK-Panel
connection at the device.
Temperature sensor
If you are using a temperature sensor for the battery II, stick the temperature
sensor to the face of the battery II (supply battery). To do so, remove the
protective plastic film from the sticking spot of the temperature sensor and
press it firmly to the desired position at battery II (see description of
temperature sensor). Connect the cable of the temperature sensor to the
temperature sensor connection of the device (2-pole connection).
Battery type changeover switch
When the device is delivered, it is set to operation with liquid electrolyte
batteries. If necessary, set the battery type (liquid or gel) of your battery II at
the changeover switch.
29
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806