Maintenance; Maintenance Schedule - Husqvarna TF230 Manuel D'utilisation

e) Make sure that the electrical wires are not
damaged.
• For TF338: Apply oil to the air filter.
To fill fuel
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
1. Stop the engine and let the product become cool.
2. Put the product in an area with good airflow.
3. Fill the fuel tank.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
4. Tighten the fuel tank cap carefully to prevent the risk
of fire.
5. Clean the product and the area around the product
from fuel spillage.
6. Move the product 3 m/10 ft or more away from the
refueling area and the fuel source before you start
the engine.
To start the product
1. Open the fuel tap. (Fig. 47)
2. Open the choke with the choke control. (Fig. 48)
3. Put the gear lever in the neutral gear position. (Fig.
49)
4. Apply full throttle with the throttle control. (Fig. 50)
5. Set the ON/OFF switch to ON. (Fig. 51)
6. Pull the starter rope handle.
WARNING: Make sure that no person or
animal is in the safety zone of 20 m
when the product starts.
7. When the product starts, set the choke control to the
choke position. (Fig. 52)
To operate the product forward
1. Use the gear lever to select drive speed. Position 1
is slow speed and position 2 is fast speed. (Fig. 53)
2. Push down the throttle lock on the handle.
3. Push the clutch lever (A) in the direction of the
handle to make the tine blades rotate. (Fig. 54)
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
12
4. Release the clutch lever (B) to make the tine blades
stop.
To operate the product rearward
1. Make sure that no obstacles are behind the product.
2. Release the clutch lever.
3. Decrease the engine speed.
4. Put the gear lever in the reverse gear position. (Fig.
55)
5. Push down the throttle lock on the handle.
6. Push the clutch lever (A) in the direction of the
handle to make the tine blades rotate. (Fig. 54)
7. Release the clutch lever (B) to make the tine blades
stop.
To stop the product
1. Release the clutch lever. (Fig. 56)
2. Put the gear lever in the N position. (Fig. 57)
3. Set the throttle control to the MIN. position. (Fig. 58)
4. Set the ON/OFF switch to OFF. (Fig. 59)
5. Close the fuel tap. (Fig. 60)
To move the product with the support
wheels (TF230)
1. Stop the engine. Refer to
page 12 .
2. Fold the support wheels down. (Fig. 61)
3. Set the handlebars in the low position.
4. Lift the tine blades from the ground with the
handlebars. (Fig. 62)
To move the product with the wheel kit
1. Stop the engine. Refer to
page 12 .
2. Replace the tine blades for the wheels. (Fig. 63)
3. Lift the drag bar from the ground with the handlebar.
(Fig. 64)

Maintenance

Maintenance schedule

* Clean at a more regular interval if the product is used
in conditions with much dust.
WARNING: Before you move the product
rearward, you must release the clutch lever
to prevent injury.
To stop the product on
To stop the product on
1419 - 003 - 09.07.2020