Changing Between Fahrenheit And Celsius; Updating Firmware - Hatco Rapide Cuisine Manuel D'installation Et D'utilisation

English
4. Turn the Control Knob to highlight either MODE S or MODE
A-ß in red, then push the Control Knob to select the desired
mode.
• MODE S = Standard Mode
• MODE A-ß = Advanced Programming Mode
• After selecting the mode, the Control Display will return
to the Power Control screen.
Temperature Control units
separate in Standard Mode.
Standard Mode

Changing Between Fahrenheit and Celsius

Use the following procedure to change the temperature unit
of measure between Fahrenheit and Celsius in Advanced
Programming Mode.
1. Push the Control Knob to start the
Induction Range.
2. Touch the Button on the control
panel to toggle through the screens
on the Control Display to the
Settings Screen.
3. Turn the Control Knob clockwise
until TEMP UNIT is highlighted in red, then push the Control
Knob to select TEMP UNIT.
• A password screen will appear.
• To enter the 3-digit password
"248", turn the Control Knob to
the first number, then press the
Control Knob to select and move
to the next number.
• The Temp Unit screen will appear.
4. Turn the Control Knob until the desired unit of measure is
highlighted in red, then push the Control Knob to select the
unit of measure.
5. Turn the Control Knob to highlight EXIT, then push the
Control Knob to return to the Settings Screen.
6. Touch the Button on the control panel to return to the
active cooking control screen.
Form No. IRNGM-0517
Menu screen appears in
Advanced Programming Mode.
Advanced Programming
Mode
Settings
Firmware Errors
Modes Temp Unit
Showroom Program
Settings—Advanced

Updating Firmware

Use the following procedure to upload firmware updates to the
Induction Range from an external USB drive. This procedure
can be done in both operation modes.
NOTE: For the latest firmware updates, cooking tips, and
more, go to the Hatco Induction Range website:
www.hatcocorp.com/rapide_cuisine
1. Push the Control Knob to start the
Induction Range.
2. Touch the Button on the control
panel to toggle through the screens
on the Control Display to the
Settings Screen.
3. Turn the Control Knob clockwise until FIRMWARE is
highlighted in red, then push the Control Knob to select
FIRMWARE.
• A password screen will appear.
• To enter the 3-digit password
"248", turn the Control Knob to
the first number, then press the
Control Knob to select and move
to the next number.
• The Firmware screen will appear.
4. Depending on the type of update, turn the Control Knob to
highlight either USER BRD or MAIN BRD, then push the
Control Knob to select.
• The Firmware Update screen will appear.
5. Insert the USB drive into the USB
port.
• The USB port is on the bottom
of countertop units, and on the
under side of the control panel
on built-in units.
6. Turn the Control Knob to highlight UPDATE, then push the
Control Knob to start the update.
• A screen will appear to indicate the update is in progress.
• When the update is complete, the Welcome screen will
appear for a few seconds showing the new firmware
version, and the unit will shut down.
13
OPERATION
Settings
Firmware Errors
Modes
Showroom
Settings—Standard