SKYTRONIC 600.032 Mode D'emploi page 12

Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by
inappropriate use or disrespect of the warnings contained in this manual.
SkyTronic UK cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to
all damages in whatever form.
WARNING
To avoid possible electric shock or personal injury, follow these
guidelines:
•
Do not use the meter if it is damaged. Before you use the
meter, inspect the case. Pay particular attention to the
insulation surrounding the connectors
•
Inspect the test leads for damaged insulation or exposed
metal. Check the test leads for continuity. Replace damaged
test leads before you use the meter.
•
Do not use the meter if it operates abnormally. Protection
may be impaired. When in doubt, have the meter serviced.
•
Do not operate the meter around explosive gas, vapour, or
dust.
•
Do not apply more than the rated voltage, as marked on the
meter, between terminals or between any terminal and earth
ground.
•
Before use, verify the meter's operation by measuring a
known voltage.
•
When measuring current, turn off circuit power before
connecting the meter in the circuit. Remember to place the
meter in series with the circuit.
•
When servicing the meter, use only specified replacement
parts.
•
Use with caution when working above 30V ac rms, 42V peak,
or 60V dc. Such voltages pose a shock hazard.
•
When using the probes, keep your fingers behind the finger
guards on the probes.
•
Connect the common test lead before you connect the live
test lead. When you disconnect test leads, disconnect the live
test lead first.