Dc Current Measurement; Resistance Measurement; Transistor Test - SKYTRONIC 600.032 Mode D'emploi

DC CURRENT MEASUREMENT

1) Connect the red test lead to the "VΩmA" jack and the black
test lead to the "COM" jack (for measurements between
200mA and 10A connect red lead to "10A" jack with fully
depressed).
2) Set the Function / Range switch to the desired DCA
position.
3) Open the circuit to be measured, and connect test leads in
series with the load in which the current is to be measured.
4) Read current value on the Display.

RESISTANCE MEASUREMENT

1) Connect the red lead to "VΩmA" and the black lead to
"COM".
2) Set the Function / Range switch to the desired "Ω" position.
3) If the resistance being measured is connected to a circuit,
turn off power and discharge all capacitors before making
measurement.
4) Connect test leads to the circuit to be measured.
5) Read the resistance value on the Display.
DIODE MEASUREMENT
1) Connect the red lead to "VΩmA", the black lead to "COM".
2) Set the Function / Range switch to "
3) Connect the red test lead to the anode of the diode to be
measured and the black test lead to cathode.
4) The forward voltage drop in mV will be displayed. If the
diode is reversed, only figure "1" will be shown.

TRANSISTOR TEST

1. Set the Function / Range switch to the "hFE" position.
2. Determine whether the transistor is PNP or NPN type and
locate the emitter, base and collector leads. Insert the leads
into the proper holes of the hFE socket on the front panel.
3. The meter will display the approximate hFE value at the
condition of base current 10µA and Vce 2.8V.
" position.