Temperature Measurement; Accessories - SKYTRONIC 600.032 Mode D'emploi

TEMPERATURE MEASUREMENT

1) Connect the K type thermocouple couple to "VΩmA" and
"COM" jacks.
2) Set the Function / Range switch to TEMP range.
3) Read Temperature value in ºC on the display.
AUDIBLE CONTINUITY TEST
1) Connect the red test lead to "VΩmA", the black test lead to
"COM".
2) Set the Function / Range switch to " " position.
3) Connect the test leads to two points of circuit to be tested. If
the resistance is lower than 50Ω. The built-in buzzer will
sound.
TEST SIGNAL USE
1) Set the Function / Range switch to "
2) A test signal will be output between "VΩmA" and "COM"
jack, the output voltage is approx 5V p-p with 50kΩ
impedance
BATTERY AND FUSE REPLACEMENT
Fuse rarely needs replacement and is blown almost always as a
result of operator's error. If "
indicates that the battery should be replaced. To replace battery &
fuse (200mA/250V) remove the 2 screws in the bottom of the case,
simply remove the old one and replace it with a new one. Be
careful to observe the polarity.

ACCESSORIES

•
Operator's instruction manual
•
Test leads
•
Gift box
•
K type thermocouple (only for 600.038)
•
9-volt battery, NEDA 1604 6F22 type.
" appears on the display, it
•" range.