Philips Saeco Syntia RI9836 Mode D'emploi page 31

Using the machine for the
first time or after a long
period of inactivity.
These simple operations will make it pos-
sible to always brew excellent coff ee.
1 Place a large container under the
dispensing spout.
2 Before starting the procedure, check
that the following icon is displayed.
Green
3 Select the pre-ground coff ee function
by pressing the "
more times.
Do not add the pre-ground
coff ee to the compartment.
The icon will appear on the display.
Green
4 Press the button to brew a long cof-
fee.
5 Wait until brewing is completed and
empty the water tank.
6 Repeat the operations from step 1 to
step 5 for 3 times; then continue with
step 7.
7 Place a container under the steam wand
(Pannarello, if supplied).
8 Turn the selector switch clockwise to set
it to the "
" button one or
" position.
The following icon will be displayed.
Green
9 Dispense water until the no water sig-
nal is displayed, then turn the selector
switch counter-clockwise to set it to
the " " position.
Red
10 At the end, fill the water tank again.
Then the products can be brewed as
described in the following sections.
Rinse/Self-Cleaning Cycle
This cycle will rinse coffee circuits with
fresh water.
The cycle is carried out:
• At machine start (with cold boiler)
• After priming the water circuit (with
cold boiler)
• During the stand-by mode (if a coff ee
product has been brewed)
• If the machine is turned off by pressing
the ON/OFF button (if a coff ee product
has been brewed).
A small amount of water will be dis-
pensed to rinse and heat all the machine
components; in this phase this icon is
displayed:
Orange
Wait for the cycle to fi nish automatically.
You can stop dispensing as well, by
pressing either coff ee button and/or
the ON/OFF button.
• 31 •