Safety Regulations; Additional Safety Instructions - EINHELL TH-HA 2000/1 Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

Additional safety instructions:

•
Ensure that the ON/OFF switch is set to "0"
(OFF) before you insert the plug into the so-
cket.
•
The nozzle reaches temperatures of up
to 600°C. Fire hazard! Wear protective
gloves and eye wear. The nozzle should
not be touched during operation.
•
Allow the hot air pistol to completely cool be-
fore putting away.
•
Never expose the unit to rain or moisture.
Store the unit in a dry place.
•
Do not leave the unit unattended. Keep out of
reach of children.
•
Never direct the air flow at people or ani-
mals. Do not use the unit to dry clothing
or hair. Do not use the hot air blower as a
hair dryer.
•
Do not use the unit near easily flammable or
explosive substances or gasses.
•
Never block the hot air flow by plugging or
covering the air flow exit.
•
Use only original accessory and replacement
parts from the manufacturer.
•
Do not wear loose clothing or jewelry. Wear
slip-resistant shoes and wear a hair net for
long hair. During operation maintain a secure
footing.
Anl_TH_HA_2000_1_SPK9.indb 13 Anl_TH_HA_2000_1_SPK9.indb 13
GB
•
Never use the unit in wet surroundings or in
areas with high humidity (bathroom, sauna,
etc.).
•
Check your work area for easily flammable
substances and materials before using the
hot air pistol.
•
Never carry the hot air pistol by the power
supply cord.
•
Only use extension cords with a minimum
cross-section area of 1,5 mm
•
Repairs (for example power supply cord
replacement) should be performed only by a
qualified electrician.
•
Do not use chemical paint removers or sol-
vents at the same time as the hot air pistol.
•
Clean the nozzle when soiled.
•
Be sure that the openings for air entry and
exit are always clean and free of dirt.
•
Hazardous or poisonous gasses can be freed
when removing paint. Be sure to provide ade-
quate ventilation while working indoors.
•
Never point the hot air directly at windows or
other glass surfaces.
•
This equipment is not designed to be used by
people (including children) with limited phy-
sical, sensory or mental capacities or those
with no experience and/or knowledge unless
they are supervised by a person who is res-
ponsible for their safety or they have received
instructions from such a person in how to use
the equipment safely. Children must always
be supervised in order to ensure that they do
not play with the equipment.
•
Fires can be caused if the appliance is not
handled carefully and correctly.
•
Take care when using the appliance near in-
flammable substances. Do not aim the pistol
at the same point for a long time.
•
Do not use in explosive atmospheres.
•
Warmth may be carried to inflammable mate-
rials which are concealed.
•
After use, let the appliance cool on the stand
before it is put away.
•
Do not leave the appliance unsupervised
when it is in operation.
- 13 -
.
2
04.12.2019 15:54:13 04.12.2019 15:54:13