Noise Emission; Contents Of Delivery; Transport And Start Up; Transport And Installation - Jet JBG-150 Mode D'emploi

4.2 Noise emission

Determined according to EN
1807:1999 (Inspection tolerance 4 dB)
Acoustic power level (acc. EN 3746):
Idling
Acoustic pressure level (EN 11202):
Idling
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
This information is intended to allow
the user to make a better estimation
of the hazards and risks involved.
4.3 Content of delivery
Bench grinder
Machine light
Abrasive wheels grit 36 and 60
2 Tool rests
2 Spark guards
2 Eye shields
Operating manual
Spare parts list

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate
in closed rooms and must be placed
stable on firm and levelled surface.
The machine must be bolted down.
For packing reasons the machine is
not completely assembled.

5.2 Assembly

If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Mount the tool rests:
There is a left and a right tool rest,
ensure that you install them correctly.
Use the bolts (A, Fig 2) and washers
(B) and mount the tool rest (C) to the
wheel housing (D).
78,2 dB (A)
70,4 dB (A)
Adjust the tool rest to within 2mm of
the grinding wheel.
As the wheel wears down, the tool
rest must be re-adjusted.
Assembly of the eye shields:
Thread two screws (E, Fig 2) through
the mounting plate (F), eye shield
(G), mounting bracket (H) and
washers (I), and fasten with nuts (J).
Mounting the spark guards and
eye shields:
Use a bolt (K, Fig 3) and washer to
mount the eye shield and spark guard
(M).
Fig 1
Fig 2
5
Fig 3
Adjust the spark guard to within 2mm
of the grinding wheel.
As the wheel wears down, the spark
guard must be re-adjusted.
Mount the bench grinder:
To prevent the grinder from moving
during operation, it must be securely
mounted to a work bench or stand.

5.3 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.

5.4 Starting operation

You can start the machine with the
green ON-button.
The red OFF-button on the main
switch stops the machine.
The machine lamp On/Off-switch is
located on top of the lamp.
Use only a max. 40W, 230V light
bulb.