Power Cord - Clean Air Optima CA-510Pro Mode D'emploi

Digital Monitor
The digital monitor on the front side of the air purifier CA-510Pro indicates automatically
and exactly current air quality by measuring the level of Particle measurement PM2.5,
indoor humidity and temperature.
Green - Good: 0-80ug/m³ Blue - Average: 80-150ug/m³ Red - Bad: 150 ug/m³ or more
Particulate matter of 10um (PM10) and smaller 2,5 um (PM2.5) can get into the lungs and
belongs to the top 10 threats for human health. These small particles develop through typical
indoor processes such as cooking, baking, frying, smoking, as well as heating or are also
transported in big quantities into indoor air because of transportation, industry, construction,
biological material (pollen, bacteria, mites, and viruses), imported particles from other regains
such as (airplane) exhaust gases and volcano eruptions.
Allergens such as pollen and dust cause serious and long-term health threats to millions
of persons each spring: the numbers are increasing constantly.
Measurement of relative humidity and temperature
Important aspects for effective air purification: relative humidity between 45 - 60% and room
temperature of about 20 - 23 °C

Power Cord

1. Remove the power cord glue from the bottom of the device and insert the end of the power
cord into the socket at the bottom of the device (as shown in figure 1).
2. Put the power line into the wire slot and fix it with the wire pressing adhesive (as shown
in figure 2).
20