Clean Air Optima CA-510Pro Mode D'emploi page 25

Troubleshooting
The following is a troubling shooting guide to help you solve any issues that you may have us-
ing the Clean Air Optima Intelligent Air Purifier CA-510Pro.
Problem
Device does not
switch on
The air outlet
smells foul
Poor purification effect
No air is blowing out
of the device
The remote control
does not work
WARNING!
If the above recommended solutions do not work, please contact Clean Air Optima technical
support at the telephone number for your region. Do not attempt to disassemble, reassemble,
or repair the device as this may void the warranty.
25
Possible Cause
The power cord does not
connect correctly
The power cord is broken
The front or back panel is not
installed correctly
The filter traps too much odor
or dust
The lifetime of the filters
has expired
Check if the humidity
in the room is too dry
The device is placed in
an unventilated room or
surrounded by obstacles
The airinlet or airoutlet
is being blocked
Check if the battery
is installed
Check if the battey is in-
stalled correctly
Check the capacity of the
battery
Check the remote control
distance exceeds the range
Solution
Connect the power plug
and power socket correctly
Replace the power cord
Install the panel correctly.
See chapter: How to use
Replace the composite filters
Replace the composite filters
Increase the humidity
Remove the obstacles
Remove the obstacles
Install the battery
Install the battery correctly
Replace te battery
Range is within 5 meters from
the front-side of the device