IWC Schaffhausen 150 Years Mode D'emploi page 11

— 2 0 —
F U N C T I O N S O F T H E C R O W N
Normal position
0 —
Time setting
1 —
N O R M A L P O S I T I O N
With the crown in the normal position (0), you can wind the watch
by turning the crown clockwise. Always wind the watch fully, to
the point at which you feel a distinct resistance in the crown. Your
watch has a power reserve of approximately 60 hours. To ensure
maximum accuracy, you should fully wind your watch every day
as a matter of routine. The crown must always be in position 0
when you are wearing your watch.
I W C T R I B U T E T O P A L LW E B E R E D I T I O N " 1 5 0 Y E A R S "
0 1
— 2 1 —
T I M E S E T T I N G
Pull out the crown to position 1. This will stop the movement.
You can then set the current time by slowly turning the crown
to the right or the left. To start the seconds hand, push in the
crown to position 0.
O P E N I N G A N D C L O S I N G T H E C OV E R
slow it down, otherwise the hinge may get damaged over time.
To close the cover, simply snap shut. Press the push­button at
I W C T R I B U T E T O P A L LW E B E R E D I T I O N " 1 5 0 Y E A R S "
You can read the time with the
cover closed.
To see the full display, press
the push­button on the crown.
The front cover will then
spring open. Please cushion
the cover with your thumb to