Beper 40.610BL Manuel D'instructions page 13

Hair clipper Use instructions
After using the cut clipper, always switch off the appliance with the button on/off on 0 (5) and unplug
the power cord. Take off the attachment comb and put the blade protection (7) after cleaning.
CUT EXAMPLE
Step 1
Attach comb attachment 3mm or 6mm.
Starting at the centre of the head at the base of the neck. Gradually and slowly lift the clipper, wor-
king upwards and outwards, through the hair, trimming just a little a time. Continue to cut the back
area from the bottom of the neck .Fig.3
Step 2
Charge to the nest longest comb attachment 9mm or 12mm and cut the back of the head.
Step 3
Charge to one of the shorter combs 3mm or 6mm, trim sideburns, i.e. the hair directly in front of the
ears. Then change one of the linger combs, 9mm or 12mm, and continue to cut to the top of the
head. Fig.4
Step 4
Using comb attachment 9mm or 12mm, cut top of head from back to front against the direction in
which the hair normally grows; comb attachments 3 mm or 6mm are used to achieve a close crew
cut or short cut
For longer hair on top, use the comb provided and lift hair on the top of the head. Cut over the comb,
with the hair lifted or hold the hair between the fingers to lift it and cut it to desired length. Fig.5
Step 5
Finally, use the taper lever without an attachment comb for close trimming around the base of the
neck, the sides of the neck and the ears. Fig.6
CLEANING
For clearing the appliance, always unplug the cord.
Take off hair from the cut clipper, after every use, with the provided brush (12) and oil the blades
with a drop of provided oil (11). Use only mineral oil, as the provided oil ; you can also use oil used
for sewing machine.
Do not use hair oil, grease, oil mixed with kerosene or any solvent. Fig.7
Clean the other parts of the curt clipper with a wet cloth.
13