Cable Connections - Muss Dental MA 30 Mode D'emploi

Am Weingarten 7 • D-30974 Wennigsen • Tel.: +49(0)5103 / 7065-0 • Fax +49(0)5103 / 7065-79
http://www.muss-dental.de • e-mail:
O P E R A T I O N
GB
Accident Prevention Regulations are to be followed!
If the handpiece is not in use, it should be placed on the handpiece holder, or on any other proper holder.
If the unit is not in proper condition or is not being handled correctly, it is possible that injuries may occur
or cause damage to the material and unit.
Unplug the Unit before Opening the Housing
The repair and maintenance of the electrical parts of the unit may only be done by professionally skilled
and trained workers, informed of the safety guidelines. New spare parts, used in repairing the unit must
be in accordance with spare-parts with the manufacturer required specifications.
Scope of Delivery/Dimensions: F203 / H240B
Operating unit, power cord, handpiece, handpiece holder, chuck key, cleaning brush, operation instructions, certificate
of warranty.
Measurement control unit:
Measurement handpiece:
Scope of Delivery/Dimensions: K203 / H240B
Operating unit, power cord, handpiece, handpiece holder, chuck key, cleaning brush, drill template, hanging, 2 screws,
operation instructions, certificate of warranty.
Measurement control unit:
Measurement handpiece:
Scope of Delivery/Dimensions: T203 / H240B
Operating unit, power cord, handpiece , treadle switch, handpiece holder, chuck key, cleaning brush, operation
instructions, certificate of warranty.
Measurement control unit:
Measurement handpiece:
Startup (according to the scope of delivery)
- Remove the device completely out of the packaging.
- Set up the table top control unit at an adequate workstation.
- Set up the foot control unit at an adequate workstation.
- Mount the knee control unit onto your table/bench according to the separate instructions (written on the drill template
MU 3061).

Cable Connections


Connect and block the handpiece at the back of the control unit at the hub

Only for table top control units: Connect and block the treadle switch at the back of the control unit at the hub

Insert the power cord into the back of the control unit. Plug the plug into the power socket.
Operation of Handpiece: H240B
Chance the burs only when the handpiece has come to a complete stop. No warranty by disregard! Turn the grip sleeve
clockwise in order to exchange the desired burs to open the mechanism (for chuck). Turn the grip sleeve counter
clockwise until it snaps in order to close it again.
Operation of Foot Control Unit: F203
Activate the foot lever into the direction of the max. speed, so the rate of revolutions will be continuously variable.
Release the foot lever, the handpiece will stop.
muss.dental@t-online.de
W 23 cm x D 26 cm x H 15 cm, weight: 3,1 kg
L 18 cm, ø 3 cm, weight: 280 g
W 33 cm x D 23 cm x H 10 cm, weight: 3,5 kg
L 18 cm, ø 3 cm, weight: 280 g
W 33 cm x D 23 cm x H 9 cm, weight: 3,5 kg
L 18 cm, ø 3 cm, weight: 280 g
I N S T R U C T I O N
.
.
Seite 10 von 20