Cable Connections; Motor Overload Protection - Muss Dental MA 31 Mode D'emploi

Am Weingarten 7 • D-30974 Wennigsen • Tel.: +49(0)5103 / 7065-0 • Fax +49(0)5103 / 7065-79
http://www.muss-dental.de • e-mail: muss.dental@t-online.de
O P E R A T I O N
GB
Accident Prevention Regulations are to be followed!
If the handpiece is not in use, it should be placed on the handpiece holder, or on any other proper holder.
If the unit is not in proper condition or is not being handled correctly, it is possible that injuries may occur
or cause damage to the material and unit.
Unplug the unit before opening the housing
The repair and maintenance of the electrical parts of the unit may only be done by professionally skilled
and trained workers, informed of the safety guidelines. New spare parts, used in repairing the unit must
be in accordance with spare-parts with the manufacturer required specifications.
Scope of Delivery/Dimensions: F300 / H310
Operating unit, power cord, handpiece, handpiece holder, chuck key, cleaning brush, instructions, and certificate of
warranty.
Measurement control unit:
Measurement handpiece:
Startup
- Remove the device completely out of the packaging.
- Set up the foot control unit at an adequate workstation.

Cable Connections


The handpiece needs to be connected and blocked at the back of the control unit at the hub

Insert the power cord into the back of the control unit. Plug the plug into the power socket.
Operation of Handpiece: H310
Chance the burs only when the handpiece has come to a complete stop. No warranty by disregard! To open the
mechanism (for chuck) you need to turn the grip sleeve clockwise in order to exchange the desired burs. In order to
close it again, you need to turn the grip sleeve counter clockwise until it snaps.
Operation of Foot Control Unit: F300
The rate of revolutions will be continuously variable by activating the foot lever into the direction of max. speed. The
handpiece stops by releasing the foot lever.
Do not clean handpiece with pressure air, also the use of oil is prohibited!

Check the chuck at least once a month and clean it.

Motor overload protection

In case of an overload, the built-in electronics will shut itself and the motor off. The unit will be ready for further use.
Storage of the product
The storage of the product needs to be guaranteed (normal room temperature and normal humidity). You need to keep
the packaging for storage/transportation purposes.
Electromagnetic compatibility of product is given, tested after EMV.
W 23 cm x D 26 cm x H 15 cm, weight: 3,1 kg
L 17 cm, ø 3 cm, weight: 240 g
I N S T R U C T I O N
.
Seite 10 von 19