Starting The Engine - Cross Tools CPG 2000 INV Mode D'emploi

Translation of the original operating instructions
5.3.

Starting the engine

2. Set the fuel cock (fig. 10, no. 8) to "ON".
4. Set the choke lever (fig. 12, no.10) to
"start" .
( )
6. Carefully pull the pull-cord starter (fig. 14, no. 5) until you
can feel a light resistance, then pull it more forcefully.
Attention! Risk of injury!
There could be an unexpected kick-back from the
pull-cord starter, which could suddenly jam the pull-cord.
If you are starting an engine that has already warmed up,
you do not need the choke!
7. After a warm-up phase (1 - 2 min.), return the choke lever (fig. 12, no.10)
to the "Running"
1.
connection (fig. 9, no.13), as well as the 12 V
connection (fig. 9, no.14) and switch on the
start/stop switch (fig. 13, no.11).
3. The tank aeration and ventilation
(fig. 11, no. 2, 3) on the tank cover must be set to the
"ON" position in order to prevent a vacuum forming in
the tank.
5. Set the start/stop switch (fig. 13, no. 11) to
"START".
position. You can now connect the consumers.
( )
Disconnect all consumers from the AC
9
27