Personal Safety - DeWalt DW367 Guide D'utilisation

heat, oil, sharp edges or moving parts. Replace damaged
cords immediately. Damaged cords increase the risk of electric
shock.
• When operating a power tool outside, use an outdoor
extension cord marked "W-A" or "W." These cords are rated
for outdoor use and reduce the risk of electric shock. When using
an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and overheating.
The following table shows the correct size to use depending on
cord length and nameplate ampere rating. If in doubt, use the
next heavier gauge. The smaller the gauge number, the heavier
the cord.
Minimum Gauge for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50
240V 0-50 51-100
Ampere Rating
More Not more AWG
Than Than
12 - 16 14 12

PERSONAL SAFETY

• Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use tool while
tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating power tools may result
in serious personal injury,
• Dress properly. Do not wear loose clothing or jewelry.
Contain long hair. Keep your hair, clothing, and gloves away
from moving parts. Loose clothes, jewelry, or long hair can be
caught in moving parts. Air vents often cover moving parts and
should also be avoided.
• Avoid accidental starting. Be sure switch is off before
• Remove adjusting keys or wrenches before turning the tool
• Do not overreach. Keep proper footing and balance at all
• Use safety equipment. Always wear eye protection. Dust
TOOL USE AND CARE
• Use clamps or other practical way to secure and support the
51-100 101-150
101-200 201-300
• Do not force tool. Use the correct tool for your application.
Not Recommended
• Do not use tool if switch does not turn it on or off. Any tool
• Disconnect the plug from the power source before making
• Store idle tools out of reach of children and other untrained
• Maintain tools with care. Keep cutting tools sharp and
2
plugging in. Carrying tools with your finger on the switch or
plugging in tools that have the switch on invites accidents.
on. A wrench or a key that is left attached to a rotating part of
the tool may result in personal injury.
times. Proper footing and balance enables better control of the
tool in unexpected situations.
mask, non-skid safety shoes, hard hat, or hearing protection
must be used for appropriate conditions.
workpiece to a stable platform. Holding the work by hand or
against your body is unstable and may lead to loss of control.
The correct tool will do the job better and safer at the rate for
which it is designed.
that cannot be controlled with the switch is dangerous and must
be repaired.
any adjustments, changing accessories, or storing the tool.
Such preventative safety measures reduce the risk of starting
the tool accidentally.
persons. Tools are dangerous in the hands of untrained users.
clean. Properly maintained tools, with sharp cutting edges are
less likely to bind and are easier to control.