DeWalt DW367 Guide D'utilisation page 15

service personnel. Always use identical replacement parts. (Refer to
Brushes for brush replacement information.)
Brushes
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.
Inspect carbon brushes regularly by unplugging tool, removing the
end cap and withdrawing the brush assembly. Keep brushes clean
and sliding freely in their guides. Always replace a used brush in the
same orientation in the holder as it was prior to removal. Carbon
brushes have varying symbols stamped into their sides, and if either
brush is worn down to the line closest to the spring, the brushes
must be replaced. Use only identical D
assemblies are available at your local service center. Always replace
the end cap after inspecting or servicing brushes. The tool should
be allowed to "run in" (run at no load without a blade) for 5 minutes
before use to seat new brushes.
While "running in" DO NOT TIE, TAPE, OR OTHERWISE LOCK THE
TRIGGER SWITCH ON. HOLD BY HAND ONLY.
Shoe Adjustment
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.
Your shoe has been factory set to assure that the blade is perpen-
dicular to the shoe. If after extended use, you need to re-align the
blade follow the directions below:
ADJUSTING FOR 90 DEGREE CUTS
1. Return the saw to 0 degrees bevel.
2. Place the saw on its side, and retract the lower guard.
WALT brushes. New brush
E
ADJUSTING BEVEL ADJUSTMENT AND DEPTH
ADJUSTMENT LEVERS
It may be desirable to adjust the depth adjustment lever or the bevel
adjustment lever. They may loosen in time and hit the shoe before
tighten ing. To tighten the levers, follow the steps below.
ADJUSTING THE BEVEL ADJUSTMENT LEVER
(DW368, DW369)
NOTE: The following instructions also apply to adjusting the
DW367 and DW368 depth adjustment lever.
13
FIG. 14
3. Loosen the bevel adjustment lever (L). Place a square against
the blade and the shoe as shown in Figure 14.
4. Using a hex wrench, turn the set screw on the underside of the
shoe until the blade and the shoe are both in flush contact with
the square. Retighten the bevel adjustment lever.
1. Using a small screwdriver, pry the lock ring off.
2. Remove the lever and rotate it in the desired direction about
1/8 of a revolution.
3. Reinstall the lock ring with the concave side against the lever.