Daikin ESFV06A6 Manuel D'installation page 3

ESFV06A6 ESFVG03A6
ESFV10A6 ESFVG06A6
ESFVG02A6 ESFVG10A6
Read this manual attentively before starting up
the unit. Do not throw it away. Keep it in your
files for future reference.
Improper installation
equipment or accessories could result in electric
shock, short-circuit, leaks, fire or other damage
to the equipment. Be sure only to use
accessories made
specifically designed for the use with the
equipment and have them installed by a
professional.
If unsure of installation procedures or use,
always contact your Daikin dealer for advice
and information.
F
eatures
Only FWV and FWM units can be mounted on the
supporting feet (e.g. in case it is impossible to mount the
unit to the wall). For FWV models it is possible to mount
the covering feet (e.g. for masking the hydraulic pipes
coming from the floor).
The height of the covering feet is 100 mm.
These options are only applicable for vertical installed
models.
Table 8 at the very end of this manual shows the names of
option kits for each unit in function of the unit size.
Depending on the type of unit, some of the supplied parts
will not be applicable.
Check out figure 1 and verify which of the supplied parts
are applicable for installing the ordered option (marked
with 3).
EFA02~10A6
Supporting + covering feet (with grille)
Supporting + covering feet
(with grille)
or attachment of
by Daikin which are
I
nstallatIon
1 Remove the filter fixed to the cabinet by means of 1/4
turn screws (see figure 2).
2 Remove the fixing screws of the cover cabinet (see
figure 3).
3 Remove the cover cabinet.
4 Set the basic unit of the unit on its back.
5 Fit the supporting feet (left and right) onto the
respective sides of the basic unit (by means of screws
4.2 x 13 mm (see figure 4)).
6 The covering feet may be installed indifferently (only
for FWV) on the right-hand or left-hand side of the
unit. The choice of the installation side is determined
by the short side of the foot that must be on the front of
the unit. Slightly tighten the self-tapping screws into
the specific holes drilled on the covering feet (see
figure 5).
7 Insert the head of the screws 2.9 x 9.5 mm into the
slots of the lower part of the side panels of the cover
cabinet. Make sure to align the internal profile of the
covering foot with the internal profile of the side panels
(see figure 6).
8 Tighten the screws.
9 Reassemble the cover cabinet.
10 Reassemble the filter.
11 Fit the front grille by securing it with 4 screws
(4.2 x 13 mm) (see figure 7). (Only for ESFVG.)
Installation manual
Installation manual
1