Selecting A Cycle - Polar DN492 Mode D'emploi

Selecting a cycle

1. The number on the control panel corresponds to the cycle that is selected.
2. To toggle the cycle between hard and soft, press the HARD key.
3. Once the required cycle's number is shown, select the desired type of operation by using the FREEZE
or CHILL key.
4. Confirm the choice by pressing the same button once again. This will start the cycle.
Cycle 1 Soft chilling for delicate
products (e.g. patisseries
and vegetables)
Cycle 2 Soft freezing for delicate
products (e.g. patisseries
and vegetables)
Cycle 3
Hard chilling for general
purpose foods (e.g. meat,
pies and lasagne)
Cycle 4 Hard freezing for general
purpose foods (e.g. meat,
pies and lasagne)
Note:
After cycles 1, 2 and 3 are complete, unit will enter a holding phase. Cabinet
will hold end temperature until the operator ends the cycle.
Temporarily stopping the running cycle
1. If a chill operation is selected, press the CHILL key to stop. If a freeze operation is selected, press
the FREEZE key to stop.
2. The compressor and the fan will stop and the icon for the current cycle starts to flash.
3. To restart the cycle, press the same key used to stop the cycle. The cycle will restart from the same
point at which it was interrupted. There will be a 2-minute delay after stopping the generator in order
to prevent the appliance from overheating.
4. If the cycle is not manually restarted, the Chiller will automatically restart after 20 minutes.
How to stop a cycle
• If a chill operation is selected, press the CHILL key once.
• If a freeze operation is selected, press the FREEZE key once.
DN492-DN493-DN494 _ML_A5_v5_20200908.indb 5 DN492-DN493-DN494 _ML_A5_v5_20200908.indb 5
1. While in standby, icons
2. Press the CHILL key once. Icon
3. To start the cycle, press the CHILL key again.
1. While in standby, icons
2. Press the FREEZE key once. Icon
3. To start the cycle, press the FREEZE key again.
1. While in standby, icons
2. Press the HARD key. Icons
indicating hard chilling and hard freezing can be selected.
3. Press the CHILL key once. Icon
4. To start the cycle, press the CHILL key again.
1. While in standby, icons
2. Press the HARD key. Icons
indicating hard chilling and hard freezing can be selected.
3. Press the FREEZE key once. Icon
4. To start the cycle, press the FREEZE key again.
UK
and will flash.
will remain on.
and will flash.
will remain on.
and will flash.
and will turn on,
will remain on.
and will flash.
and will turn on,
will remain on.
2020/9/8 14:03 2020/9/8 14:03
5