Safety Tips - Polar DN492 Mode D'emploi

UK

Safety Tips

• Position on a flat, stable
surface.
• A service agent/qualified
technician should carry out
installation and any repairs
if required. Do not remove
any components or service
panels on this product.
• Consult Local and National
Standards to comply with the
following:
- Health and Safety at Work
Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• DO NOT use jet/pressure
washers to clean the
appliance.
• DO NOT use the appliance
outside.
• DO NOT use this appliance
to store medical supplies.
• DO NOT allow oil or fat to
come into contact with the
plastic components or door
seal. Clean immediately if
contact occurs.
2
DN492-DN493-DN494 _ML_A5_v5_20200908.indb 2 DN492-DN493-DN494 _ML_A5_v5_20200908.indb 2
• Always carry, store and
handle the appliance in a
vertical position and move
by holding the base of the
appliance.
• Always switch off and
disconnect the power supply
to the unit before cleaning.
• Keep all packaging away
from children. Dispose of
the packaging in accordance
with the regulations of local
authorities.
• If the power cord is
damaged, it must be
replaced by a POLAR agent
or a recommended qualified
technician in order to avoid a
hazard.
• This appliance is not
intended for use by persons
(including children) with
reduced physical, sensory or
mental capabilities, or lack
of experience or knowledge,
unless they have been given
supervision or instruction
concerning the use of the
appliance by a person
responsible for their safety.
2020/9/8 14:03 2020/9/8 14:03