Powerhead Maintenance; Wall Mount Installation - Soniclean STV-1 Digital Stick Vacuum Mode D'emploi

POWERHEAD MAINTENANCE

REMOVING THE BRUSHROLL
First, make sure the vacuum is turned off and the battery is removed. To release the
brushroll, press the brushroll release button (shown below in step 1) and pull the brushroll
out of the powerhead. To reinstall the brushroll, follow this procedure in the reverse order.
MAINTAINING THE BRUSHROLL
To ensure optimal cleaning performance, regularly check the brushroll and brushroll end cap
and remove any string, hair or debris that may be wrapped around the brushroll. You can
carefully use a pair of scissors to remove any debris, however, be sure not to cut anything
other than hair, string, fibers or other debris.
NOTE: Any damage to the powerhead or vacuum caused by improper maintenance or
the lack of maintenance is not covered by the warranty.
13

WALL MOUNT INSTALLATION

The Soniclean STV-1 Digital Stick Vacuum includes a wall mounting kit to store your
vacuum. To install the wall mount, you will need to use the following tools:
• Power drill with drill bit
• Pencil
• Phillips head screwdriver
DRILLING THE PILOT HOLES
Position the wall mount at your desired height, making sure that the wall mount is level. Use
the three holes in the wall mount to mark the location of the holes using a pencil. Once the
holes have been marked, slowly and carefully drill the three pilot holes approximately 1/2
inch (~13mm) deep.
INSTALLING THE WALL MOUNT
Insert the three included anchors into the pilot holes that you have just drilled. After,
inserting the anchors, align the wall mount holes with the anchors and secure the wall
mount to the wall by screwing in the three included screws. Be sure not to overtighten the
screws.
14