QEO FL 510HV-G TRACKING Mode D'emploi page 51

OPERATION
POWER ON
Press the ON/OFF button once to power on the receiver.
The LCD display will initialise taking about 0.5 seconds when
all the display symbols are illuminated (see diagram, left).
The receiver is now ready for use (see diagram, right).
SELECT ACCURACY SETTING
Power on the unit and select the receiving accuracy fine, normal or coarse by pressing the „accuracy
button" . The default accuracy setting following Power is „Fine" .
SWITCH ON /OFF THE SOUND
Power on the receiver and press the button „Sound/illumination" to select the sound and volume
required. The symbols in the LCD display show the status of the sound and volume.
1 5
fine normal
± 1 mm ± 5 mm
high off
9
coarse
± 9 mm
low
EN
51