Operation - QEO FL 510HV-G TRACKING Mode D'emploi

EN
F

OPERATION

Power on the instrument on with button
After switching on the instrument the display shows automatically:
· the battery status of the instrument.
· the preparation of the TILT mode (the TILT LED is blinking slowly); if the instrument is not disturbed
within 30 sec, the TILT mode is active; (see also: TILT function)
· status SLOPE +00.000 %.
· channel CH2 of the remote control;
if a remote is active and can receive a signal the indication is
if no remote is active the indication is
·
· WVS and MAN mode are not yet active; no display indication.
At the same time the self-levelling procedure starts.
If the self-levelling procedure is completed the laser starts rotating with 600 rmp.
ROTATING SPEED
Press the button to select the rotating speed: 1100, 600 or 300 rpm (after switching on the laser it
automatically rotates with 600 rpm).
AREA SHIELD FUNCTION
Press the button to shield one or more areas of the laser beam.
The area shielded is shown in the display.
Note:
It is not possible to shield all four areas at the same time - one area must remain active.
SLEEP/MANUAL FUNCTION
Press this button once to enter into the SLEEP mode. The instrument and the remote control are now in
standby mode. All values set will be stored. After restart the instrument will work with the same values
as before.
Note: After 60 min. in standby function the laser automatically switches off.
Press the button again to re-activate the instrument and the remote control.
Press the button long to enter into the MANUAL mode.
Now the laser can be used in slope postion as the instrument does not power off or re-level automa-
tically.
38