Functional Description; Removing/Inserting The Battery - Milwaukee M18 FUEL Manuel De L'utilisateur

FUNCTIONAL DESCRIPTION

1
6
5
4
1. ON/OFF switch
2. Speed control dial
3. Collet / collet nut
4. LED (not shown)
5. Spindle lock
6. Micro adjustment
dial
14
7. Quick release
lever
8. Macro adjustment
button
9. Gripping surface
10. Depth turret
11. Micro adjustment
sleeve
12. Handles
13. Depth gauge knob
14. Plunge release
lever
15. Depth gauge
indicator
16. Depth gauge
17. Shaft / housing hole
SYMBOLOGY
Volts
Direct Current
No Load Revolutions per Minute (RPM)
Read Operator's Manual
UL Listing for Canada and U.S.
C US
Cat. No. 2723-20
Fixed base
9
8
16
Plunge base
15
13
12
11
10
Offset base
9
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
2
WARNING
may be hazardous.
Always remove battery from tool before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
The collet must be attached to the collet nut before
installing the collet assembly to the tool. Be sure
that the collet size matches the size of the bit shank,
otherwise the collet may break.
3
1. To assemble, place collet on an even surface, and
place the nut over the collet.
2. Press down on the nut to snap the nut and collet
together.
3. To disassemble, use a rod to push the collet out
7
of the nut.
Installing/Removing Bits
WARNING
accessories or making adjustments.
Use only specifically recommended accessories.
Others may be hazardous.
Never use bits larger than the smallest of the
openings in the base, sub-base, or dust shroud.
The use of larger bits can result in loss of control
and possible serious personal injury.
7
Do not tighten the collet nut without inserting the
bit. The collet may break.
Never touch the bit during or immediately after
use. After use the bit, collet, and collet nut may
be hot enough to burn bare skin.
1. Turn the On/Off switch to OFF (O) and remove
7
the battery pack.
2. Place the router upside down on a workbench.
17
3. Press and hold the spindle lock and use the 11/16"
wrench to loosen the collet nut counterclockwise
(or use the 7/16" spindle lock wrench to hold the
spindle securely).
4. Insert the bit shank into the collet as far as it will go.
5. Back the bit shank out slightly to avoid bottoming
out.
6. Be sure there is a
minimum of 1/16"
between the bot-
tom of the collet
assembly and the
radius to the cut-
ting portion of the
bit.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this tool. Others
Installing Collets
Always remove battery from the
tool before attaching or removing
Collet nut
Minimum
1/16"
Collet
Bit
shank