emerio WH-125971 Mode D'emploi page 5

21. Always unplug the appliance when not in use.
22. The appliance is hot when in use. To avoid burned, do not
let bare skin touch hot surfaces.
23. The supply voltage and utility frequency, specified on the
machine, need to match those of the socket that is used.
The electrical socket that you are using must be to hand at
all times in order to be able to remove the plug from the
socket in the event of an emergency.
24. Fully extend the cord before plugging in the heater. Make
sure it does not come into contact with any part of the
heater and prevent it from heating up any other way. Do
not run the cord underneath carpeting; do not cover it
with mats, carpet strips or similar and make sure it is not
placed in any passageways. Make sure the cord cannot be
stepped on and that no furniture is placed on top of it. Do
not lead the cord around sharp corners and do not roll it
up too tightly after use!
25. If possible, do not use an extension cord, as this causes
the risk of overheating and fire. If the use of an extension
cord is unavoidable, then make sure it is an undamaged,
approved extension cord with a minimum diameter of 2 x
1.5 mm² and a minimum permissible power of 1000 Watt.
To prevent overheating, always fully extend the cord!
26. Do not use the heater outdoors and do not use it in
spaces, smaller than 7 m³.
27. Always switch the heater off, unplug it and leave to cool
down before:
- cleaning the heater
- carrying out maintenance on the heater
- touching or moving the heater.
28. Keep the heater clean. Dust, dirt and/or a buildup of
deposits in or behind the heater are a common cause of
overheating. Make sure these deposits are removed
regularly.
29. The appliance (incl. cord and plug) may only be opened
- 4 -