Precautions; Specifications - Sony DPS-V55M Mode D'emploi

Additional Information

Precautions

On safety
• Should any liquid or solid object fall into the unit, unplug the
unit and have the unit checked by qualified personnel before
operating it any further.
On power sources
• Before operating the unit, be sure that the operating voltage of
your unit is identical with that of your local power supply.
• Unplug the unit from the wall outlet if it is not to be used for an
extended period of time. To disconnect the cord, pull it out by
grasping the plug. Never pull the cord itself.
• AC power cord must be changed only at the qualified service
shop.
On placement
• Place the unit in a location with adequate ventilation to prevent
heat build-up and prolong the life of its components.
• Do not place the unit near heat sources, or in a place subject to
direct sunlight, excessive dust or mechanical shock.
• Do not place anything on top of the cabinet which might block
the ventilation holes and cause malfunctions.
On cleaning the cabinet
• Clean the cabinet, panels and controls with a soft cloth lightly
moistened with a mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent such as alcohol or
benzine.
On repacking
• Do not throw away the carton and the packing material. This
makes an ideal container when transporting the unit. When
shipping the unit, repack it as it was packed at the factory.
If you have any question or problem concerning your unit that is
not covered in this manual, please consult your nearest Sony
dealer.
When requesting repairs, all user program data (#201~400)
will be reverted to the original factory data settings.
Before requesting repairs, be sure to save your important data
using an external MIDI data filer, or by making written notes
of the parameter settings.
20
GB

Specifications

A/D Converter
20 bit resolution
D/A Converter
20 bit resolution
Sampling
Frequency
48 kHz
Input (rear panel)
reference maximum
Jack type input level input level
PHONE –10 dBu +20 dBu
or +4 dBu
Input (front panel)
reference maximum
Jack type input level input level
XLR/ –50 dBu +10 dBu
PHONE
Output
reference maximum
Jack type output level output level
PHONE –10 dBu +10 dBu
or +4 dBu or +20 dBu
MIDI Input/Output
Jack: 5 pin DIN (IN x 1, OUT/THRU x 1)
OUT/THRU can be set to either OUT or THRU
Frequency Response
20 Hz ~ 22 kHz (+0, –1 dB)
Signal–to–Noise
Ratio
Greater than 93 dB
Distortion
Less then 0.005% (1 kHz)
Effect Algorithms
45 (4ch: 9, 2ch: 27, Mono-Pair: 9)
Memory
Preset 200 locations (numbers 001~200)
User 200 locations (numbers 201~400)
Power Source
AC 230 V, 50/60 Hz
Power Consumption
12 W (230 V)
Dimensions
482 x 88 x 290 mm (WxHxD not including
projections)
Mass
approx. 3.6 kg
Supplied accessories
Operating Instructions (1)
Effect Parameter Guide (1)
Preset Memory Catalog (1)
Design and specifications subject to change without notice.
input
impedance circuit type
More than unbalanced
45 kilohms
input
impedance circuit type
10 kilohms balanced
load
impedance circuit type
less than 1 unbalanced
kilohm