Sony DPS-V55M Mode D'emploi page 14

Editing a Program
Choosing the Structure
This function lets you choose the structure of the effect
blocks. Note, this setting is only possible when you have
selected effects for both FxA and FxB. (It is not possible
when using 4ch effects).
1
Press Fx TYPE to display the effect type
screen.
F x T y p e : T y p e
F x A :
2
Press EDIT PARAMETER / to display
"Struct".
The structure symbol starts blinking.
F x T y p e : S t r u c t
F x A : 1 1
3
Turn the rotary encoder to select "/" or
"m".
The structure symbols correspond to those printed on
the front panel below the display.
/ : Parallel
Allows you to use FxA and FxB separately.
With this structure, channels 1 and 2 are processed
separately from channels 3 and 4.
m : Serial
Allows you to feed the output of FxA into FxB for
additional processing.
With this structure, channel 1 is mixed with channel 3
and channel 2 is mixed with channel 4.
4
Press EXIT to return to play mode.
14
GB
1 1 / F x B : 1 2
/ F x B : 1 2
Changing the Parameters
Use the following procedures to:
• Turn an effect on or off,
• Adjust individual effect parameters (FxA or FxB)
• Adjust the master volume (output) of the program.
For descriptions of the parameters available for each effect, refer to
the separate Effect Parameter Guide.
1
Press EDIT PARAMETER ? or /
repeatedly to display the parameter you
want to adjust.
2
Turn the rotary encoder to change the
parameter.
3
Repeat steps 1 and 2 to change all
necessary parameters.
Press EDIT PARAMETER ? and / at the same time
to skip to the next parameter group instead of
switching parameters one at a time.
The name of the parameter group is shown at the top of
the display. The individual parameters and parameter
values appear at the bottom.
Parameter group
E d i t : F x O n / O f f
F x A O n / O f f
Parameter
Parameter group
Fx On/Off
FxA [effect name* 2 ]
1 2
FxB * [effect name* ]
Master Level
* 1 There are no FxB parameters when FxA is a 4ch effect.
* 2 The effect name is abbreviated to 5 characters.
3
* Refer to the separate Effect Parameter Guide for detailed
information.
4
Press EXIT to return to play mode.
O n
Setting
contains parameters that
1
Turn FxA and FxB* off or on.
Change the sound produced by
FxA. The number and type of
parameters available depends on
the effect block.* 3
Change the sound produced by
FxB. The number and type of
parameters available depends on
3
the effect block.*
This parameter lets you adjust the
output level of the current
program.