LENCO LBT-120 Mode D'emploi page 8

4. REC:
Press it to enter into record mode.
5. SPLIT/PAIR (BLUETOOTH)
Split function: For stopping the current recording, forming a record file manually and then going
on recording the next track.
Pair function: Press this button until the LED indicator starts flashing blue, then put your Bluetooth
speaker or headphone into pairing mode. Then this turntable will connect with the Bluetooth
speaker or headphone automatically and the LED indicator will be blue without flashing after the
connection is made. The wireless music playback can start. You can start streaming the music
wirelessly!
Press this button till the LED indicator becomes blue flashing and the Bluetooth connection is
disconnected.
Remark: When you try to pair the turntable, better close the Bluetooth function of the Bluetooth
products within 10 meter that you do not want to pair.
6. Pick-up arm stand
7. Pick-up Arm Lift Stick:
To raise up and down the Pick-up Arm and cue at a proper place of a vinyl.
8. Pick-up Arm Lock:
Use this to lock the Pick-up Arm when not in use or for transportation.
9. Dust Cover:
Use this to protect the turntable from exposure to dust. The cover may be opened or removed
during use, but should remain closed when the turntable is not in use.
10. RCA Line Out Cable
Connect the RCA line out to a mixer or an amplifier in your sound system.
11. Power Switch:
For turning the power on or off through this switch. Please switch off the unit after finishing the
playing to save the energy..
12. Power Adaptor
Connect this adaptor to an AC outlet of the proper voltage.
13. USB Port Input:
Plug in a USB Pen Drive for recording the music from a record.
* The design is only for USB Flash Drive. To prevent the power supply is not sufficient and
overheated of the circuit(IC), always get the external power supply if using a hard drive.
14. Reject
Press it to force the arm to return directly to the arm rest
15. LED
- USB Record Operation and LED Signal Indication
- USB storage device is not plugged. -> LED light is off
- USB storage device is plugged in -> LED flashes
- When the system is ready to record. -> LED light is on
- Press REC button to start recording. -> LED blinks slowly.
- Press SPLIT button to create new file in the recording.
8