Avdel AV 30 Manuel D'instructions page 30

Specification
Intent of Use
The AV™30 Installation Tool is principally a piston and cylinder assembly. When coupled hydraulically and electrically to
a compatible hydraulic power source and the relevant nose assembly is attached, it is then used to install 1/2" to 5/8"
Avbolt ® and 1/2" to 3/4" Infalok
The placing tool and hydraulic pump unit may only be used in accordance with the operating instructions for placing
®
Avdel fasteners.
Refer to the table below for the list of applicable fasteners and associated nose equipment.
Refer to the datasheets listed in the table for the relevant nose assembly instructions.
FASTENER
TYPE
AVBOLT ®
INFALOK ®
Refer to the illustration on page 6 for the identification of the nose assembly dimensions 'A' and 'B'.
The safety instructions must be followed at all times.
Placing Tool Specification
Pressure:
Noise Level: Less than
Vibration: Less than
Hydraulic Oil: Enerpac
Product Range:
Additional Features:
® in Industrial Environments.
SIZE PART NUMBER
1/2" 73412-03600
5/8" 73412-03400
1/2" 73412-03100
5/8" 73412-03200
3/4" 73412-03300
SPECIFICATION
Pull at stated pull pressure
Force:
Push Off at stated return pressure
Pull
Return
Stroke: Piston Stroke
Weight: Without nose equipment
® Hydraulic Oil – HF-95X
Avbolt ®
Infalok ®
Stem Ejection – Front or Rear
Seal Arrangement
Hydraulic Bearing Rings
Protective Handle / Hose Gator
Protective Hose Guard
Hose / Cable Retention Clamps
NOSE ASSEMBLY
DIM. 'A' DIM. 'B'
113 mm 43 mm
113 mm 52 mm
113 mm 43 mm
115 mm 48 mm
134 mm 56 mm
METRIC
175.0 kN
80.0 kN
510 bar
200 bar
41.0 mm
6.9 kg
80 dB(A)
2.5 m/s²
12.7 to 15.9 mm
12.7 to 19.1 mm
Front
Yes
Yes
Yes
NOSE ASSEMBLY
DATASHEET
PART NUMBER
07900-00905
07900-00905
07900-00919
07900-00919
07900-00919
IMPERIAL
39341.0 lbf
17985.0 lbf
7397 PSI
2901 PSI
1.61 in
15.3 lb
8 ft/s²
1/2 to 5/8 in
1/2 to 3/4 in
Lip and Wiper Seals
Yes – Front
5