Connecting Your System - Pioneer ELITE SW-E10 Guide D'utilisation

English
4

CONNECTING YOUR SYSTEM

CAUTION: All power should be turned off to your system before any connections are made. Careful attention should be
taken to ensure that all electronic components are not connected to an AC source. Not doing so could result in potential
damage to the system.
Correct wiring of your subwoofer is essential for achieving the best sound quality. We recommend the use of a high-quality
interconnect cable or cables between your receiver or preamp and the subwoofer.
METHOD 1: FOR HOME THEATER OR
LFE APPLICATIONS
1. On the rear of the A/V receiver or surround processor, there
should be a single RCA type jack marked SUBWOOFER
OUT. Connect a single RCA cable from that jack to the
top jack on the rear of the subwoofer labeled LEFT/LFE.
A standard male to male RCA cable is needed.
2. After connecting the cable to you're A/V receiver or sur-
round processor and subwoofer, plug your subwoofer
into an AC outlet. Do not use the AC outlet on the rear of
your receiver. After plugging in the unit, switch the Main
Power to ON.
3. See Final System Adjustments, below.
Connect to
subwoofer output
of receiver
METHOD 2: FOR STEREO APPLICATIONS
1. On the rear of the receiver or preamp there should be
stereo (left and right) RCA type jacks marked LEFT and
RIGHT PREAMP OUTPUT. Connect a pair of RCA cables
from those jacks to the LEFT/LFE and RIGHT inputs on
the rear of the subwoofer. Two standard male to male
RCA cables are needed.
2. After connecting the receiver or preamp to the subwoofer,
plug your subwoofer into an AC outlet. Do not use the AC
outlet on the rear of your receiver. After plugging in the
unit, switch the Main Power to ON.
3. See Final System Adjustments, below.
www.pioneerelectronics.com
Connect to
line outputs
of receiver