Table des Matières
Publicité
RELAIS – POUR COMMUTER LES CANAUX D'AMPLIS
As we cannot list schematics of all amps here, we
suggest that you simply try which of these options results
in the desired channel selection. For your amp this could be:
OOOO = Clean channel
OCOO = Crunch
CCOO = Drive channel
In the Support section on www.tcelectronic.com, you will
find schematics on how to make cables for some popular
amps. If your amp type is not represented here, please
contact a technician for help or consult the manual for
your amp or ask the manufacturer for details.
Example
Let us assume the following:
•
You have a regular combo-amp with a clean channel
and a lead channel.
•
The connector for the channel switching on the amp
is a regular stereo jack connector.
•
You wish to make two presets: one with the clean
channel selected and one with the drive channel
selected.
Setting up
•
Connect a stereo-to-stereo 1/4" jack cable from SW
OUT1 or SW OUT2 on the back of the GFX01 to the
channel switch connector on your amp.
•
Recall the preset you wish to combine with your
amp's clean channel.
•
Scroll through the Rel.A combinations until your
amp's clean channel is selected.
Set the Relay parameter to A and store the preset.
EDIT A
EDIT B
A
:
B
0C00
: 0000 :
Note that the "A" setting showed above is a pure guess,
as we do not know exactly which amp you use.
•
Find and recall the preset you wish to combine with
your amp's lead channel.
EDIT C
: Relay
A
•
Again, scroll through the Rel.A combinations; but this
time, stop once your amp's drive channel is selected.
•
Set the Relay parameter to A and store the preset.
This could be the setting for your lead channel:
EDIT A
EDIT B
A
:
B
CC00
: 0000 :
•
Store the preset.
What Can the "B" Option Be Used For?
Each preset can store two Relay configurations. You can
assign a switch to toggle between these configurations
(Toggle) or to temporarily activate the second
configuration (Hold).
As a result, the G-System can select the amp channel of
your choice at preset change. Then, within that preset,
you can use a switch assigned to "Relay" to alternate
between Relay A and Relay B settings.
Example:
You have a three channel amp. Clean, Crunch and Lead.
You have designed a nice Crunch sound that you use in
the beginning of a solo. Later you wish to go to the Lead
channel but otherwise keep the same effects.
•
Set Relay to "A" and select the Crunch channel using
encoder A.
EDIT A
EDIT B
A
:
B
CC00
: 0000 :
•
Then set Relay to B and select the Lead channel
using encoder B.
•
Set Relay to "A" again and store the preset.
•
Now set up a switch to alternate between Relay A
and Relay B and you are ready to go.
To learn more about setting up switches, please refer to
the "Custom Setup of Switches" section.
EDIT C
: Relay
A
EDIT C
: Relay
A
49
Publicité
Table des Matières
