Filling With Water - Reliable Velocity V50 Guide D'utilisation

FILLING WITH WATER

If during ironing the tank runs dry, after 30 seconds the operation/temperature
LEDs (5) of all the levels will start to flash. If the V50 is used without water for a
period of one minute, the micro-pump will stop.
Disconnect the iron, keep it in an upright postion and refill the tank using the cup
(6) that comes with it Fig 1. Plug the iron in again.
Once the V50 is plugged in, only the LED of the selected operation/temperature (5)
will light up.
NOTE: If the user fills the V50 without having it unplugged first, the LEDs will
continue blinking until the user presses the steam activation button (4) and the iron
steams for approximately 15 seconds.
ANTI - SCALE SYSTEM
This iron is equipped with a permanent anti-scale cartridge system installed
strongly recommended that you use the best water that is available to you as
outlined earlier in this manual.
CLEANING
using EZ-OFF iron cleaner. Please follow the instructions on the package.
B) Outer casing
certain plastic parts and/or remove the graphics.
secure it with the clip.
pull the cord too tightly when winding it around the iron on the first turn.
08