Troubleshooting; Ce Certification; Repair - Amprobe IR608A Mode D'emploi

Troubleshooting

Code
---(on display)
Battery icon
appears
Blank display
Laser doesn't work

CE Certification

This instrument conforms to the following
#
standards
EN 61326-1 Electromagnetic Emissions and Susceptibility
EN 61010-1 General Safety
EN 60825-1 Laser Safety
Between approximately 250Mhz and 800 Mhz at 3V/m, the
instrument may not meet its stated accuracy.

Repair

All test tools returned for warranty or non-warranty repair or for
calibration should be accompanied by the following: your name,
company's name, address, telephone number, and proof of
purchase. Additionally, please include a brief description of the
problem or the service requested and include the test leads with
the meter. Non-warranty repair or replacement charges should
be remitted in the form of a check, a money order, credit card
with expiration date, or a purchase order made payable to
Amprobe® Test Tools.
In-Warranty Repairs and Replacement – All Countries
Please read the warranty statement and check your battery
before requesting repair. During the warranty period any
defective test tool can be returned to your Amprobe® Test Tools
distributor for an exchange for the same or like product. Please
check the "Where to Buy" section on www.amprobe.com for a
list of distributors near you. Additionally, in the United States and
Canada In-Warranty repair and replacement units can also be
sent to a Amprobe® Test Tools Service Center.
Problem
Target temperature
is over or under
range
Possible low
battery
Possible dead
battery
Low or dead
battery
5
Action
Select target
within
specifications
Check and/or
replace battery
Check and/or
replace battery
Replace battery