DeLonghi DFP250 Mode D'emploi page 5

use of original spare parts and accessories.
• When the appliance is to be discarded, after
unplugging from the outlet, cut the cable to
make the appliance unusable.
• Save these instructions in a safe place for future
reference.
• Avoid contacting moving parts.
Misuse of your processor/blender can result in
•
injury.
Refer to the relevant section under "using the
attachments" for additional safety warnings for
each individual attachment.
• The use of attachments not recommended by
the manufacturer may cause a risk of injury to
persons.
• Do not use outdoors.
• Do not let cord hang over edge of table or coun-
ter.
• Do not let cord contact hot surface, including
the stove.
• Keep hands and utensils out of container while
blending to reduce the risk of severe injury to
person or damage to the blender. A scraper may
be wed to used but must be used only when the
blender is not running.
• To reduce the risk of injury when using the mill,
Before plugging in
- Make sure your electricity supply is the same as the one
shown on the underside of your machine.
- This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no.
1935/2004 of 27/10/2004 on materials intended for con-
tact with food.
Before using for the first time
1 Remove all packaging including the plastic blade covers
from the knife blade. Take care the blades are very sharp.
These covers should be discarded as they are to protect the
blade during manufacture and transit only.
2 Wash the parts see 'cleaning'
3 Push excess cord into the back, of the machine.
SAVE THESE INSTRUCTIONS
For Household use only
never place cutter-assembly blades on base
without jar properly attached.
• To protect against risk of electrical shock do not
put in water or other liquid
• Note: The maximum power rating is based on
the knife blade attachment.
• Always operate blender with cover in place.
• When blending hot liquids, remove center piece
of two-piece cover.
• The use of attachments, including canning jars,
not recommended by the manufacturer may
cause a risk of injury to persons.
• Keep hands and utensils away from moving bla-
des or disc while processing food to reduce the
risk of severe injury to persons or damage to
food processor.
• To reduce the risk of injury, never place cutting
blade or discs on base without first putting bowl
properly in place.
• Be certain cover is securely locked in place befo-
re operating appliance.
• Do not attempt to defeat the cover interlock
mechanism.
To use your food processor
1 Fit the detachable drive shaft into the power unit (1).
2 Then fit the bowl. Place the handle towards the back and
turn clockwise until it locks (2).
3 Fit an attachment over the drive shaft.
Always fit the bowl and attachment onto the machine
before adding ingredients.
4 Fit the lid (3) - ensuring the top of the drive shaft locates
into the center of the lid.
Do not use the lid to operate the processor, always
use the on/off speed control.
5 Switch on and select a speed.
The processor won't work if the bowl and lid are fit-
ted incorrectly. Use the pulse control for short bursts. The
pulse will operate as long as the control is held in position.
6 Reverse the above procedure to remove the lid, attach-
ments and bowl.
5