Technical Data; Functions - Inventum IKI9045FLOW Manuel D'utilisation

Problem
The display on the control panel of
the cooker hood shows S.
The display on the control panel of
the cooker hood flashes 8.
BREAKDOWN CODES
The breakdown codes are shown on the operation indicator on the control panel of the induction hob.
Breakdown code
E
Er03
E2 / EH
E3
E6
E8
10

Technical data

FUNCTIONS

Item
Independent cooking timer
Independent cooking alarm
Pan sensor
Residual heat indicator
Child lock (*)
Protection against incorrect connection
Booster mode (*)
Bridge mode
(*) applicable for both the induction hob and the cooker hood.
38 • English
Possible cause
The charcoal filter is worn.
There is too much condensation or
liquid present in the appliance.
Possible cause
-
The touch buttons are covered.
The appliance is overheated.
The pan is not suitable for an
induction appliance.
There is a defect in the mains
supply.
The ventilation opening of the fan is
blocked.
Specification
Individual for all zones
Yes
Yes
Yes
Yes
Yes
2 rear cooking zones / yes
1
Possible solution
1. Replace the charcoal filter. Refer
'Replacing the
to section
charcoal filter (optional)'
2. Reset the alarm. Refer to section
'Resetting an alarm'
.
1. Drain the liquid. Refer to section
'Draining the appliance'
2. Reset the alarm. Refer to section
'Resetting an alarm'
.
Possible solution
Contact Inventum Huishoudelijke
Apparaten B.V.
Remove the blockage.
Let the appliance cool down.
Use a pan that is suitable for an
induction appliance. Refer to section
'Requirements for pans'
.
Do a check on the voltage and the
frequency of the mains supply.
Remove the blockage.
.
.