Program Playback; Aux In Function - Trevi CMP 531 USB Mode D'emploi Et Installation

PROGRAM PLAYBACK

Programming can only be made when the CD/ MP3 playing is stopped.
Programmed playback enables tracks on a disc (normal audio CD or MP3 CD) or USB
to be played in the desired order.
1. Press STOP button (4) to stop the playback.
2. Press the PROG/+10 (2), "P01" indicator will be displaying in the LCD.
3. Press SKIP UP (9) or SKIP DOWN (3) to select the desired track no.
4. Press once the PROGRAM BUTTON again to memorize the first selected track
5. Repeat steps 2 and 3 until all desired tracks are programmed.
6. Press the PLAY/ PAUSE/USB (8) to start playing.
7. Press the STOP button (4) twice to stop programmed playback.
8. Open the CD DOOR or turn off the unit to clear the programmed memory.
MP3 USB FUNCTION
1. Set FUNCTION SWITCH (12) to CD/MP3.
2. Connect the USB Flash Drive into the USB port (13).
3. If the audio CD in the compartment, press and hold the PLAY/PAUSE/USB button
(8) to select the USB function.
4. If USB is readable, the display will show USB and the total number of tracks after a
few seconds.
5. Press the PLAY/PAUSE/USB button to start playback.
6. Press the STOP (4) button to stop play songs. The display will show the total number
of tracks.
7. To use the repeat functions refer to chapter "Playing Songs" described in OPERATION
PLAYING COMPACT DISC.
CAUTION:
Do not use any USB extension cable to connect the USB stick as it may cause harmful interference.
In case of malfunction due to electrostatic discharge, just reset the product (reconnect the power
socket) to resume normal operation.

AUX IN FUNCTION

To listen to an external audio source, you need a stereo 3.5mm plug cable (Not included)
1. Connect one end of the 3.5mm plug into the output of the audio source, and the
other end of the 3.5mm plug into the AUX IN JACK.
2. Set the FUNCTION SWITCH (12) to CD/MP3. The ON indicator (5) will light on and
"AUX" indicator will be displaying in the LCD (6.7).
3. Play the audio source.
4. Adjust the VOLUME KNOB (14) for your desired listening level.
Now you can listen to the audio playing from the audio source through the unit.
5. To turn off the unit, set the FUNCTION SWITCH (12) to the OFF position.
NOTE: Remeber always unplug the 3.5mm plug cable from the unit after used.
12