Aventics VTM Notice D'instruction page 44

44 AVENTICS | VTM | R402002668-BDL-001-AC
Instructions
Explanation
6. Repeatedly press the function button until the display shows
"Time".
7. Press "Enter" to choose time measurement.
8. Repeatedly press the flank setting button until the display
shows rising and falling flanks (5).
9. Press "Enter". The display shows "Start ?".
10. Press "Enter" again to start measurement.
11. To start a new time measurement, press "Enter" to set the
instrument to standby for measurement.
When the switch on the box is turned to "Start", a signal is sent to
the instrument and to the M12 "Start" connector. When the switch
is turned to "Return", a signal is sent to the M12 connector
"Return". The cylinder is sent to the starting position. For unistable
valves, only the "Start" connector is connected.