Instructions; Commissioning; Velocity Measurement - Aventics VTM Notice D'instruction

7

Instructions

7.1

Commissioning

Note: The cylinder may only be commissioned by a specialist in
pneumatics or by a person under the control and supervision
of such a specialist (see "Personnel qualifications", page 31).
7.2

Velocity measurement

Note: The meter can only measure the velocity of cylinders that
have a magnet.
Fig. 4: Meter with velocity probe connected
1. Plug the connector of the probe (1) into the meter.
2. Switch on the instrument by pressing "On".
3. The word "Velocity" appears on the display. If not, press the
function button repeatedly until it does.
4. Press "Enter" to choose velocity measurement.
5. Position the probe at least one metre from powerful magnets
or wires carrying a high current, and calibrate it by pressing
"Cal".
AVENTICS | VTM | R402002668-BDL-001-AC
Velocity
Reset Cal.
Enter
Velocity-Time-Meter
37
Instructions
1
00123800