Time Measurement With Pnp Sensors - Aventics VTM Notice D'instruction

7.3
Only valid for VTM adjusted for PNP.
7.3.1
Fig. 6:
1. Apply the sensors (1) to the cylinder.
2. Using the extension cables (see item 5 on page 34), connect the
3. Switch on the instrument by pressing "On".
4. Repeatedly press the function button until the display shows
5. Press "Enter" to choose time measurement.
6. Press the flank setting button until a falling and a rising flank
7. Press "Enter". The display shows "Start ?".
8. Press "Enter" again to start measurement.
9. To repeat the time measurement, press "Enter" to set the
Explanation With a falling flank, triggering takes place when the voltage goes
from high to low. With a rising flank, triggering takes place when
the voltage goes from low to high.
AVENTICS | VTM | R402002668-BDL-001-AC

Time measurement with PNP sensors

Measurement with two proximity sensors
3
On/Off
Reset
Velocity-Time-Meter
The meter with two proximity sensors applied to a cylinder
M8 connectors (2) of the sensors to the meter, as shown.
"Time".
appears on the display (3).
instrument to standby for measurement.
2
Cal.
Enter
39
Instructions
1
00123802