QSC AcousticDesign AD-S52 Manuel D'utilisation page 4

Mounting (continued)
Ball Mount Adapter
The included ball mount adapter can be attached to almost any
flat surface. The ball mount adapter's back plate can be removed,
if desired. This will reduce the overall depth of the assembly and
the footprint of the mount on the wall.
To use the wall mount adapter, secure to the mounting surface
using four screws. Ensure the mounting surface is sufficiently
strong to support the loudspeaker and any vibration or seismic
activity. Connect the wiring to the loudspeaker and install the ter-
minal cover, if desired. Thread the adapter into the threaded insert
on the bottom of the loudspeaker. Adjust the angle of the loud-
EN
speaker and tighten the hardware fully. We recommend 12 lbs.-ft
(15 N-m) of tightening torque be applied to both fasteners.
Optional Yoke Mount
There is an optional yoke mount available, model YM-5. Contact
your QSC Audio Products representative for details.
Connection
AD-S52 or AD-S52T?
Connection is the same for both models, but for the AD-S52T you
must set the transformer Tap Selector Switch to the appropriate
setting before applying audio.
Terminations
The binding post terminals will accept:
•bare wire (up to 0.15" or 3.8 mm diameter)
•spade lug terminals
•banana plugs (singles or dual 0.75" spaced)
Input Connection Cover (wire termination only)
The loudspeaker includes a weather resistant cover for the input
terminals. For proper sealing, the cable jacket must be round (or
close to round) and be between 0.12" (3mm) and 0.25" (6.3mm)
outside diameter.
•Pass the wires through the compression nut, gasket, and
cover.
•Loosen the binding post nuts.
•Strip the wires and insert into binding posts.
•Tighten nuts.
•Slide the cover over the terminals and secure using the two
machine screws provided.
•Ensure gasket is seated properly; tighten compression nut.
To assure weather-tight connections, make sure the
Input Cover fits flush against the loudspeaker cabi-
net, all gaskets are properly placed, and hardware
is tightened sufficiently. Use of the Input Cover may
require the use of smaller wire sizes for proper fit.
NOTE! You cannot use banana type connectors or
spade lugs when the Input Connection Cover is
used. Connect the wires directly to the terminals
when using the Input Cover.
4