Program Selection - Sammic GLASS-PRO GP-35 Manuel De L'utilisateur

Operation
3.2 Main operating elements
Fig. 2: Control panel and buttons
1
a
1 ON/OFF button
2 START button
3 PROG button
Buttons
ON/OFF button
•
Main functions: Turns the machine on and off.
– With the machine in standby, the
– With the machine turned on, the
START button
• Main functions:
– Start of the wash cycle.
– Confirmation of setting parameters.
– With the door open, activate the "auto start" option.
PROG button
• Main functions: selection of the washing pro-
gramme.
Indicator/warning icons
Icon Indication/warning
In standby mode it is on, pressing the ON/OFF button
switches it off and starts the filling and heating sequence.
Machine ready. It switches on when the tank and boiler have
reached the setpoint temperature.
Heating the machine during preparation. Thermal lock: it
flashes when the boiler has not yet reached the setpoint tem-
perature at the time of rinsing.
Proceso lavado.
Proceso aclarado.
Auto start: if it is on, this option is active. When the option is
active, the machine starts the cycle automatically when the
door/dome is closed.
User's manual — 2900450/0
2 3
d
c
b
a Machine status
b Program/cycle
c Auto start
d Cycle phase: washing or rinsing
icon is on.
icon is off.
3.3 Turning the machine on.
1) Press the ON/OFF button.
⇒
All icons light up simultaneously for 2 seconds.
⇒
Thermal lock activated: when the power is turned off, the
icon continues to flash for 2 seconds and then turns
off.
2) The machine heats up the rinsing boiler and the tank one after
the other.
⇒
While the machine is filling with water, the
flashes. The cycle CANNOT start until the set water level is
reached.
⇒
When the working level is reached, the machine closes the
water inlet by means of a pressure switch and one of the
cycle lights comes on. [Fig. 2/b]
3) The machine heats the rinsing boiler and the tank one after the
other.
⇒
While the machine is heating up, the
⇒
The machine is ready for use when the pre-set temperatures
are reached in the boiler (between 75 and 85 °C, depending
on the program) and in the tank (between 50 and 65 °C
depending on the configuration). At this point, the
on the control panel comes on.
⭆
The estimated time for this operation is approximately
30 minutes.
3.4 Main operation
3.4.1 Prewash
1) Remove any remaining dirt and rinse the items
before putting them in the dishwasher.
2) Place the items in the dishwasher basket.
3) When the basket is full, open the door of the
machine and enter the basket centered on the support guides.
3.4.2

Program selection

1) To select the wash program that best suits the type of item you
want to wash, press the PROG button
2) Select the type of wash cycle by pressing the PROG button
With each press, a different cycle is selected from the program
list [Fig. 2/b]
Icon Description
GLASSES Cycle
JUGS cycle
icon
light flashes.
light
.
.
Icon Description
DRAIN Cycle
17
EN