Symbols; Noise Level; Assembly And Introduction - LEMAN TAB050 Manuel D'utilisation

- contact with tool;
- contact with moving parts (belts, pulleys, etc..);
- recoil of the piece or part of it;
- accidents due to wood splinters or fragments;
- tool insert ejection;
- electrocution from contact with live parts;
- danger due to incorrect tool installation;
- inverse tool rotation due to incorrect electrical connection;
- danger due to dust inhalation in case of working without vacuum cleaner.
Bear in mind that the use of any machine tool carries risks.
Use the appropriate care and concentration for any type of machining (also the most simple).
The highest safety is in your hands.

2.5 Symbols

The following symbols are located on the machine, nameplate, and carton box:
Do not dispose of electric tools together with
household waste material.
Read and understand the instruction manual
before using the machine.
Wear eye protection.
Wear ear protection.

2.6 Noise level

- Sound Pressure Level:
- Sound Power Level:
Wear ear protection!
The noise levels measured are emission levels and not necessary the safe working level. Although there is a
correlation between the emission levels and the exposure levels, this cannot be used reliably to determinate
whether or not further precautions are required. The factors which affect the actual level of operator exposure
include the duration of exposure, the ambient characteristics and other sources of emission, for example, the
number of machines and other adjacent machining. The permitted exposure values may also vary from country.
Nevertheless, this information allows the user of the machine to better evaluate the dangers and risks.
Other factors which reduce exposure to noise are:
- correct tool choice;
- tool and machine maintenance;
- use of hearing protection system (e.g. headsets, earplugs, ...).
CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect to the plug from the power
receptacle.
The machine must not be plugged in and the power switch must be in the OFF position until the
installation is complete.
- Carefully remove all contents from the shipping carton. Compare the contents with the list of contents to make
sure that all of the items are accounted for, before discarding any packing material. Place parts on a protected
surface for easy identification and assembly. If any parts are missing or broken, please call the Customer Service
for replacements. Do not turn your machine ON if any of these items are missing. You may cause injury to
yourself or damage to the machine.
- Clean all rust protected surfaces with ordinary household type grease or spot remover. Do not use flammables;
gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces.
GB
No load<80dB(A) Load<90dB(A)
No load<90dB(A) Load<100dB(A)

3. ASSEMBLY AND INTRODUCTION

26
Machine nameplate
Machine must be earth grounded.
Wear dust mask.