Inserting / Changing Batteries In The Remote Control - BluMill Power Air Cooler Mode D'emploi

1. Make sure that the device is not connected to the mains power.
2. Flip open the cover (1).
3. Carefully pour cold tap water into the water tray (17). When you do this, make sure
that the water tray does not overfl ow.
4. Flip the cover shut.
The water runs out of the water tray into the water tank (10) below the honeycomb filters
(4).
Alternative Filling
To fill the water tank, the device may
alternatively also be taken apart.
1. Release the two closure clasps
(11) of the water tank on the sides
of the device by levering them up
from below.
2. Reach into the recessed grips,
lift up the top part of the device
and detach it from the water
tank. Please note!Always place
the detached part down on a
moistureresistant surface.
3. Fill the water tank (Picture C).
4. Place the detached part of the device on the water tank. Make sure that the water
level indicator (6) is facing forwards.
5. Fix the water tank with the closure clasps on the housing (13).
For an even better cooling result, ice packs (not supplied with the device)
or ice cubes can optionally also be placed in the water tank.
INSERTING / CHANGING BATTERIES IN THE REMOTE
CONTROL
Before inserting the batteries, check whether the contacts in the remote control and on
the batteries are clean, and clean them if necessary.
1. Slide open the battery compartment cover in the direction of the arrow and take it off.
2. Take out used batteries if necessary and replace them with two new batteries (1.5 V;
AAA). Pay attention to the correct polarity (+ / –).
3. Place the battery compartment cover on the battery compartment and slide it counter
to the direction of the arrow to shut it.
Replace the batteries if the power of the remote control starts to wane.
2020-11-18 OCG BluMill Power Air Cooler - V07326 Manual V02.indd 11 2020-11-18 OCG BluMill Power Air Cooler - V07326 Manual V02.indd 11
EN
11
03-12-2020 16:00 03-12-2020 16:00