Cleaning And Storage - BluMill Power Air Cooler Mode D'emploi

CLEANING AND STORAGE

Please Note!
•
No liquid must get into the device (with the exception of the water tray and the water
tank). Never immerse the device in water!
•
Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the device.
These may damage the surfaces.
•
Make sure that the device is not connected to the mains power.
•
Wipe down the device with a soft, damp cloth. Remove more stubborn dirt with a little
mild detergent.
•
Keep the device operational and clean the honeycomb filters (4) if necessary.
•
If the device is not going to be used for a prolonged period and before storing it away,
it is essential to remove any remaining water from the water tank (10).
•
Store the device in a clean, dry place so that it is protected and is out of the reach of
children and animals when it is not in use.
CLEANING AND STORAGE
Cleaning the Honeycomb Filters
•
When rinsing the honeycomb fi lter, the water pressure must not be too great and the
jet of water must not be too strong. This could damage the honeycomb filter.
•
Do not use any acidic or alkaline cleaning agents.
1. Undo the screws on the honeycomb fi lter covers (5) and take them off.
2. Grab a honeycomb fi lter cover on both sides at the top edge, press against the
housing (13) with your thumbs and thus release the honeycomb fi lter cover from the
housing. You need to apply a little force to do this.
3. Lift the honeycomb filter cover up out of the housing at an angle.
4. Tilt the honeycomb filter (4) towards you at the top and lift it up out of the device at an
angle (Picture E).
5. Repeat steps 2 to 4 for the remaining three honeycomb fi lters.
6. Rinse the honeycomb filters under running water.
7. Allow the honeycomb filters to dry completely.
8. Insert the honeycomb filters into the device.
9. Place the honeycomb filter covers in the
housing and press them against the housing
by their top edges. When you do this, make
sure that the locking lugs at the bottom
of the honeycomb filter cover fit in the
corresponding recesses in the housing.
10. Fix the honeycomb filter covers in place with
the screws.
2020-11-18 OCG BluMill Power Air Cooler - V07326 Manual V02.indd 13 2020-11-18 OCG BluMill Power Air Cooler - V07326 Manual V02.indd 13
EN
13
03-12-2020 16:00 03-12-2020 16:00