PT
DE
IT
FR
If you change the receiver box, you must pair the control to the box so that the
scooter operates correctly.
Follow the steps below in order to pair them:
- Switch the scooter off by turning the key towards the OFF position.
- Remove the battery, wait a few seconds and then put it back.
- Turn the scooter on with the key. Look for a small button in the receiver box (at
the bottom of the box). Press the button for 5 seconds approximately. You will hear
four beeps. (If the scooter emits just one beep, repeat the process, as this means
that an error has occurred).
- Press and hold the
The control will then be paired.
If you find the problem that you can not solve it by yourself, please contact your
dealer for further consult and assistance.
Maintenance
There are few parts of MOBICLINIC scooter that require maintenance.
The following issues must be checked and maintained periodically:
The connection of the battery and electrodes
Ensure the electrode connections are tight and have no corrosion.
·
The battery should be placed flatly inside the battery holder.
·
Wire Coonector
·
Check all the wire connectors regularly.
·
Check all the wiring insulation condition, including the plug of the charger regu-
larly.
·
Repair or change the damaged connector and connector joint.
ABS Plastic Cover
Control panel, front cover, footboard and back cover are all made by durable ABS
·
plastic with baking finish on the surface. Do not use oil or other chemical liquids to
wipe the scooter. In order to prevent the electrical components from damage, do
not wash the scooter from the tap directly.
Bearings and Motor/ Transmission Parts
·
The components have injected lubricant and are sealed; therefore, it is unneces-
sary to inject lubricant any more.
·
Protect all the electronic components from moisture, such as control panel,
battery charger and other electric controlled components.
·
If some components become damp, please dry it before use.
39
EN
ES
button on the remote control until you hear three beeps.
Ulises