Alesis Elevate 5 MKII Guide D'utilisation page 5

Features
Rear Panel
1. RCA Inputs: Use the included
audio cable or other RCA cables
(sold separately)
external sound sources to these
inputs.
2. 1/4" Inputs: Use 1/4" (6.35 mm)
cables (sold
connect an
source to these inputs.
3. Bass Boost: This 2-position
switch allows you to boost the
speakers' bass frequencies.
4. Output to Left Speaker: This is
the audio connection to the left
speaker. Use the included 1/4"
(6.35 mm) interconnection cable
to connect the right speaker to
the left speaker.
5. Input from the Right Speaker: This is the audio connection to the right speaker. Use the
included 1/4" (6.35 mm) interconnection cable to connect the left speaker to the right
speaker.
6. Power On/Off Switch: Turns Elevate 5 on or off. To save energy, Elevate 5 will
automatically power off after 30 minutes of not receiving an audio signal from its inputs.
Once Elevate 5 detects an audio signal from its inputs, it will automatically power on again.
7. Power Connector: Plug the included power cable here.
Front Panel
1. Tweeter: This outputs the high
frequencies.
2. Woofer: This outputs the low
frequencies.
3. Headphones:
1/8" (3.5 mm) headphones to
this output to hear the mix
through your headphones. Note
that while headphones
connected to Elevate 5, you will
not be able to hear sound out of
your speakers
headphones are disconnected.
4. Volume: This knob is used to
adjust the volume
speakers.
5. Bass Port: The bass port augments the bass generated by the woofer to increase the low-
frequency SPL over that of non-ported speakers. Make sure this hole is not obstructed
since this will adversely affect bass response.
to connect
separately) to
external sound
Connect your
are
until the
of the
1
3
6
2
7
4
1
5
2
5
1
5
5
2
3
5
4
5