Introduction - Walter SURFOX 204 Manuel De L'utilisateur

1

Introduction

Introduction
Congratulations on purchasing the finest electrochemical
weld cleaning and passivation equipment available today.
WALTER's SURFOX
TM
easily and cost effectively removes the heat tint from heat
affected zones while completely passivating the stainless
steel surface.
Our new generation of SURFOX machines are equipped
with self-regulating inverter boards, automatically monitoring
and adjusting the current so as to ensure maximum clean-
ing effectiveness without loss of productivity.
Before starting, please read the SURFOX owner's manual
completely as we take you step-by-step through the start-
up, operating and maintenance procedures of your new
SURFOX equipment. Your new SURFOX machine has been
built with extra durability to stand up to the heavy demands
of industrial use. However, like any piece of electrical equip-
ment, care and safety should always be taken when using
and maintaining this valuable investment. With proper care
and maintenance your SURFOX equipment will provide
years of dependable service.
To learn more about the other WALTER products, visit our
website: www.walter.com
2
weld cleaning equipment quickly,
Operation
The SURFOX machine works by an electrochemical process
to clean and passivate welds on stainless steel. SURFOX
electrolyte solutions are phosphoric acid based, approved
for food industry, and are activated by an electrical cur-
rent to clean welds. The process takes only a few seconds
without damaging or scratching the surface of the parts to
be cleaned.
Your SURFOX machine can clean:
TIG welds
u
Plasma welds
u
Laser welds
u
Spot welds
u
MIG welds (with Pulse technology)
u
Basics of passivation:
The cleaning of the welds is not only for aesthetic
u
purposes but most importantly for passivation.
Passivation is the treatment of stainless steel surfaces
u
to remove contaminants and promote the formation of
a thick and durable protective chromium oxyde layer.
This passive layer will insure the corrosion resistance of
u
stainless steel.
If passivation is not done properly, stainless steel and
u
heat affected zones may start to rust.